What are QTEL's ADSL line parameters?
I have a Belkin Wireless N1 adsl Modem/Router and looking for the adsl line parameters for setting up the modem for one of QTEL's adsl lines which is soon to be installed(ie , tyepe of connection such as PPPoE LLC/Snap, VPI, VCI, Connection Type, UserName, Password, leased time-permanent/demand Static IP address & Gateway address - Primary & secondary, DNS Server addresses - Primary & Secondary). Regretfully, finding out this info from QTEL is being somewhat difficult!
Yea, you could just call up QTel, I guess they would help you thru.
Or, plug in your router to your adsl cable, and router to your computer.
key in http://192.168.1.1 in your browser (you need to check if its the same for belkin)
This address takes you to your routers configuration.
Go to WAN settings, and key in your internet username and password.
Go to Wireless settinsg, key in an SSID and WEP password.
You really don't need to set anything else. Save it and you should be ready to go.
Take off your cable from router to computer. And you should be ready to go wireless.
Hope this helps.
God bless..
Encapsulation: PPPOA/PPPOE try both but usually PPPOA works
VC Settings
Multiplexing: VC
Qos Type: UBR
Pcr Rate: cps
Scr Rate: cps
Autodetect: Enable
Virtual Circuit: 8 vpi 35 vci
username:s4xxxxxx or g4xxxxxx
password :xxxxxxx
Thats all u have to change in the router setting.
No issue in getting the help from qtel.call 111 from your land line where adsl is connected and ask them to help you in installation.they will help you online
i did not have any problem got any prob from qtel to get my modem installed